• active inline microphone preamplifier
  
• great when large-diaphragm dynamic microphones or ribbon microphones do not provide enough Output for your own preamp
• is wired between microphone and audio interface / Preamp
• Ultra low-noise JFET input
• Balanced signal path (in/out)
• 26 dB true analog gain
• Selectable 100 Hz (12 dB) high-pass filter
• Selectable 3 kHz (2.5 dB) high-shelf boost
• Input impedance: 2.4k Ohm
• Max input: -11 dBu (218mV rms)
• Max-Output: 15 dBu (4.36V rms) THD+N @ 15dBu: -100dB (0.001%)
• Output noise: 7.75 and (A-weighted) at 150 Ohm input
• Frequency response: 10-100kHz +/-0.2 dB
• 48v phantom power with 4.7mA current consumption
• suitable for use with low-output ribbons and dynamics in the studio
• for both vocals and instruments
• suitable for voiceover/podcast use of low-output ribbons & dynamics
• Compensation of signal loss with long cable runs
• Dimensions: 6.9 x 4.1 x 11.9 cm
• Weight: 340g

Does your Preamp have too little power? No problem with the Warm Lifter

The Warm Lifter from Warm Audio is an active inline microphone preamplifier for low output voice coil and ribbon microphones, with premium features for live and studio use. The Warm Lifter provides 26 dB of analogue gain with true impedance matching, allowing any low output microphone to be preamplified for connection to audio interfaces or mixing consoles. In addition to amplification, the Warm Lifter also features a switchable 100Hz high-pass filter and a 3kHz high-shelf boost for sound shaping. The Warm Lifter is built with high-quality components and robust materials and is 100% tested by trained technicians with a passion for making music in Austin, Texas.