Palmer trave
71,40 €
SKATT INGÅR
Passive Re-Amplification Box, for playing out DAW/mixer signals to guitar/bass amplifier, road-ready enclosure
Fri frakt på tusentals varor
100 % säkra onlinebetalningar
30 dagar tillgängliga för att returnera varorna
Passive Re-Ampflication Box
- For playing out DAW/mixer signals to guitar/bass amplifier
- Eliminates ground loops, ground lift switchable
- Processing of balanced line signal for unbalanced instrument input
- Optimal impedance matching
- Unaltered sound transmission
- Input level switchable -10dBV/+4 dBu
- Output level continuously adjustable
- Passive operation, no power supply necessary
- Road-ready housing made of aluminum and steel
- Incl. a rewritable tour label to attach to the back of the trave
- Engineered in Germany
Eliminates ground loops
With the Palmer trave passive re-amplification box, you can send the previously recorded "naked" DI signal from a guitar or bass to the amplifier and pick up its sound via microphone. The Palmer trave eliminates hum loops - which otherwise almost inevitably occur when you connect an audio interface or mixer output to an instrument amplifier. At the same time, the trave converts the line signal into an unbalanced signal with optimally matched impedance. Of course, the correct level is also important. The input can be switched between consumer level (-10 dBV) and professional level (+4 dBu); the output level can be adjusted continuously so that your amplifier works with exactly the right drive.
This allows you to re-mic your guitar tracks at your leisure after the session, or run the same DI signal through multiple amps and different amp settings in succession to achieve a wide-screen sound. With trave, there are no limits to your creativity!
Technical data
General
- Type: passive
- Number of channels: 1
- Isolated transformer: Yes
- Number of inputs: 1
- Input type: balanced
- Input connectors: XLR
- Number of outputs: 1
- Output type: unbalanced
- Output connectors: 6.3 mm jack
- Ground lift switch: yes
- Other functions: Input Level switch, Output Level potentiometer
- Housing material: extruded aluminum
- Height: 140 mm
- Width: 50 mm
- Depth: 68 mm
- Ambient temperature (operating): -20 - 70 °C
- Relative humidity: <80% (non-condensing)
- Accessories (included): Label (tour label), rubber feet
- Weight: 0.395 kg
Audio
- Max. Input level (< 1% THD, 20 Hz): +19 dBu
- Max. Input level (< 1% THD, 1 kHz):+32 dBu
- Frequency response (±1 dB, relative 1 kHz): 10 Hz - 20 kHz
- Input impedance (1 kHz, max. level, -10dBV): 5 ohms
- Output impedance (1 kHz, max. level, -10dBV): 4.2
- THD (30 Hz, +4 dBu, unity, unweighted): <0,08%
- THD (1 kHz, +4 dBu, unity, unweighted): <0,003%
- IMD (SMPTE) (60 Hz / 7 kHz, 4:1, +4 dBu): <0,004%
- Transformer ratio: 1:3
PAH0023019-000
Datablad
- Signal Processing
- Passive
- Manufacturer
- Palmer
OFTA KÖPT TILLSAMMANS
PRODUKTER FRÅN SAMMA MÄRKE
Passive Re-Amplification Box, for playing out DAW/mixer signals to guitar/bass amplifier, road-ready enclosure
Palmer trave
71,40 €
SKATT INGÅR